Heat Recovery Unit - VUT 600 WH EC

Extractor Fans | Heat Recovery Systems | Heat Recovery Unit - VUT 600 WH EC

Heat Recovery Unit - VUT 600 WH EC

Ref: VUT 600 WH EC

From: £2,712.00 (Incl. VAT @ 20%)

Select A Quantity:

Whole House Heat Recovery Unit

Easy to install, high efficiency, low energy!

Recovers up to 85% of heat extracted from your home.
Energy efficient EC motor.
Fully insulated, low noise for loft mounting.
600 m3/h extract rates.
Condensation drain included.
MVHR Appendix SAP Q Approved.
Recommended by the Energy Saving Trust.

Features
Thermal Efficiency
Controls
SAP Q
Download Manual

Heat Recovery Ventilation Unit

A highly efficient, affordable heat recovery ventilation unit. It delivers filtered, fresh air into your home, and extracts stale, moist and dirty air with minimal heat loss.

MVHR Appendix SAP Q Approved.
Recovers up to 85% of heat extracted from your home.
Energy efficient EC motor; only 2x175 watts running power.
Fully insulated, low noise for loft mounting.
Fully speed controllable up to 600 m3/h extract rates.
Highly efficient, washable, GRP cross-flow heat recovery ventilation unit.
Washable filters included in the unit.
Water heater included.

Mount the fully insulated heat recovery ventilation unit in your loft space.
Extract air from your wet, warm rooms; like your kitchen, toilet, bathroom, utility room etc.
Supply fresh, warmed, filtered air into your living areas and bedrooms.
A full range of grilles, ducting and fittings are available on-line.

safe start-up and shutdown of the unit.
supply air temperature controlling by means of actuating three-way valve regulating the feed of the heat medium into the water coils.
water (glycol) heating coils freezing protection
controlling the heat exchanger by-pass actuator.
control of the external circulation pump operation installed on the heat medium feed line entering into the water coils.
heat exchanger freezing protection.
control of the intake and exhaust fan operation.
air clogging control according to engine hours.
control of the external intake and exhaust air flow regulating damper actuators.

Air handling unit is equipped with the remote
control panel that provides:

starting-up/shutdown of the ventilation unit.
setting the required air flow.
setting the required supply air temperature.
displaying the temperature in the room.

The unit is equipped with built-in automation system with multifunctional control panel with graphic LCD indicator. The standard delivery set includes 10 m wire for connection to the control panel. Electronic
freezing protection is applied to prevent the heat exchanger freezing. It includes the by-pass damper
and the heater. It operates due to opening of by-pass air shutter as the temperature sensor requires to let
the air flow pass through the heat exchanger through the by-pass duct. During the heat exchanger defrost
cycle the supplied air is warmed up in the heater up to the required temperature. During the defrost process
the warm exhaust air warms the heat exchanger. After that the by-pass damper closes again, the
heater is switched off, supply air warms up again through the heat exchanger and the unit continues operating under rated conditions.

Download Appendix SAP Q MVHR Test Results For - VUT 600 WH EC Heat Recovery Unit.

Download manual here